WWW.RAINPROCO.COM
18 PRO 2
PRO 2 Decoder Programming Instructions
PRO 2 Decoder Programming Instructions
1. Set the controller in the Off position, Turn the rotary switch to position #11
1. Set the controller in the Off position, Turn the rotary switch to position #11
1. Set the controller in the Off position, Turn the rotary switch to position #11
(Rain Off Auto On/Off) use the (SET 4) arrow key to turn the setting from
This will stop any program that is running and prevent any from starting while
Disconnect the 2 eld wires if connected at the Terminal marked Line Out.
3. Set the Rotary switch to the “Run” position. Position 12.
4. Press (SET 1) arrow key up to access the Set Decoder ID screen.
5. Connect the two red wires of the decoder to the programming port at the bottom of
5. Connect the two red wires of the decoder to the programming port at the bottom of
the controller board marked
the controller board marked
One Red wire in each of the Terminals
One Red wire in each of the Terminals
Connect the decoders’ 2 black wires to the position marked “check”. One black wire
Connect the decoders’ 2 black wires to the position marked “check”. One black wire
each in the Terminals marked Black. See below.
each in the Terminals marked Black. See below.
6. Using the arrow key corresponding directly underneath the ID number in the
6. Using the arrow key corresponding directly underneath the ID number in the
Display (Set 2) arrow key select the desired number for that decoder
Display (Set 2) arrow key select the desired number for that decoder
7. Press the arrow key corresponding to “ENTER” on the display (right up SET
7. Press the arrow key corresponding to “ENTER” on the display (right up SET
8. The LED on the controller marked “PROGRAMMING LED” will ash 3 times.
8. The LED on the controller marked “PROGRAMMING LED” will ash 3 times.
9. Remove the red and black leads.
9. Remove the red and black leads.
10. Install “decoder number identication tag”
10. Install “decoder number identication tag”
11. If programming more than one decoder repeat from step 5.
11. If programming more than one decoder repeat from step 5.
To end programming press (SET 1) down arrow key.
To end programming press (SET 1) down arrow key.
not resume “RUN” automatically.
not resume “RUN” automatically.
13. Re-connect the eld wires.
13. Re-connect the eld wires.
Set the controller back to ON to resume Auto programming.
Set the controller back to ON to resume Auto programming.
Set the controller back to ON to resume Auto programming.
Set the controller back to ON to resume Auto programming.
position #11. Press (SET 4) arrow key to turn the setting from OFF to ON.
position #11. Press (SET 4) arrow key to turn the setting from OFF to ON.
15. Rotate Dial to Run position #12.
15. Rotate Dial to Run position #12.
DO NOT PROGRAM DECODERS WITH SOLENOIDS CONNECTED.
(24 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern