Hit-products Pro-Two Bedienungsanleitung PDF herunterladen (Seite 22)

WWW.RAINPROCO.COM

Programmable Decoder Number Identication Tags

Hit Products has developed a user friendly, exible means to identify the number of the

eld-programmed decoders during the decoder programming process. Inside every box

of programmable decoders, you will nd one set of identication tags numbered 1-16.

You will use these decoder identication tags as follows:

1. Every time a decoder is programmed, nd the corresponding numbered identication

tag and immediately attach to decoder.

2. To attach identication tag to decoder, insert one red decoder wire into the hole (from

front to back) to the left of the appropriate numbered tag as you are looking at the num

-

ber. Pull red wire all the way through the hole until identication tag is approximately one

inch from body of decoder.

Note

:

This will leave the engraved number unobstructed by the wire.

3. Insert same end of same red wire back through hole (from back of tag towards front)

and continue to pull wire through until tight. The number on the tag should now be read

-

ily visible

4. Should decoder ever be reprogrammed to a different number, make sure to replace

the identication tag with the appropriately numbered identication tag. Failure to do so

can create extreme confusion!

Hit-products Pro-Two Bedienungsanleitung Seite 22